toyota gt86

[Nouman]

hi 

subaru lock mcu

number mention on mcu

16863

th200005

itg2131

 

i try all ways but programmer not accept the boot mode

every time error come

no response from the device

 

 

[Nouman]

But when I read from cpt it only read. And it's reading mean module is okay

But not going on boot mode

Even i read and follow all instructions 

Even in saw the videos but still same issue

[Nouman]

My ecu no is 98221cc060 

[IKS]

 

[Nouman]

Which type of permission I need? 

[IKS]

exactly the one that was shown to you.

[Nouman]

Sorry I didn't understand 

[IKS]

https://t.me/gcthelp/37

[Nouman]

Where I get this driver 

If u have link kindly send me

[Nouman]

I found only this which one I download? 

[IKS]

1 час назад, IKS сказал:

 

click on it

[Nouman]

Thanks tmo i will try and update u

[Nouman]

Hi i download that driver now it's working

But didn't unlock ecu

Can I put back stage 2 resistance 

Only remove one for stage 1

Showing

20231029_142307.heic

20231029_142558.heic

[IKS]

https://t.me/gcthelp/35

 

you can try both options

[Nouman]

Hi i read file now one issue come my ecu number 98221cc060

But in calculator it's 

98221cc010

[Nouman]

? 

[IKS]

4 часа назад, Nouman сказал:

 

98221cc010

Yes. You can use this number

[hacper]

Hi,
I have the same problem, no connection to the device.
I have the correct silicon labs 6.7.4.261 drivers installed
I tested without a USB hub and with a USB hub
What could be wrong?
I can share my computer via teamviewer

 

[hacper]

I think is not good

Can somebody send me good tested Gprog? I will send this one back.

Or how I can check this one?

Aready put in good possition but still connection error

[hacper]

Solved  

I try to unlock now, which setting are the best to unlock this unit?

98221CC060

[kilya31]

какой процессор стоит в блоке?

[hacper]

16863

[kilya31]

15 часов назад, hacper сказал:

I think is not good

Can somebody send me good tested Gprog? I will send this one back.

Or how I can check this one?

Aready put in good possition but still connection error

Это исправили? 

[hacper]

Yes, unlock is also done, this are my settings

98221CC060 Subaru

Stage 1 N-F ( on stage 2 can't connect to device)
Port delay 70
Baud rate 50000
Sec_del 4
3.3V / 160000hz
Connected power to Gprog external board, without this can't unlock mcu.

[kilya31]

Перемычку переставляли по питанию, для работы с внешним   питанием? 

У вас скорее всего не хватает питания с порта usb