kilya31

Администраторы
  • Content count

    847
  • Joined

  • Last visited

  • Days Won

    206

kilya31 last won the day on July 29

kilya31 had the most liked content!

About kilya31

  • Rank
    GCT FOSUM USER

Контакты

  • site:
    https://vk.com/arhairbag
  • Skype
    kilya31

USB key Number

  • Serial
    GCT00300

Информация

  • country
    Россия
  • Location:
    Архангельск
  • Пол
    Мужчина / man

Recent Profile Visitors

2,638 profile views
  1. If the flash is damaged, then there will be no connection for diagnostics, we tried to do diagnostics on the table, if the CAN block needs a 120 Ohm resistor to put on CAN
  2. the CAN block has a bus, not a K-line?
  3. If there was a dump, it would be in the program database But there is no dump
  4. If the flash is only write, the processor will erase and write the flash when writing
  5. This means that the flash was damaged when it was not connected correctly
  6. If wrong access, it means that the flash is nailed by an incorrect connection Search for flash from a block
  7. Судить буду строга, правила раздела написаны для всех
  8. What was done, what is now a definition error?
  9. You shouldn't read it, you should reset it
  10. Capacitors about which you spoke, they are not necessary, once again check the soldering of the processor, it is difficult to see, but the soldering is not very good
  11. Solder the processor back on the block and throw it on the K-line, I completely forgot to say about it
  12. Have you read any JTAG processors?
  13. Check if the processor is properly installed on the adapter Did you read anything on JTAG?
  14. Adapter H8SX need, read flash, if no flash in the program's database and is not read via CAN to save flash next time you have a unit with that number, and you saved the flash, you can put already at the uart
  15. What is not lucky, does not read?