kilya31

Администраторы
  • Content count

    847
  • Joined

  • Last visited

  • Days Won

    206

Everything posted by kilya31

  1. If the flash is damaged, then there will be no connection for diagnostics, we tried to do diagnostics on the table, if the CAN block needs a 120 Ohm resistor to put on CAN
  2. the CAN block has a bus, not a K-line?
  3. If there was a dump, it would be in the program database But there is no dump
  4. If the flash is only write, the processor will erase and write the flash when writing
  5. This means that the flash was damaged when it was not connected correctly
  6. If wrong access, it means that the flash is nailed by an incorrect connection Search for flash from a block
  7. Судить буду строга, правила раздела написаны для всех
  8. What was done, what is now a definition error?
  9. You shouldn't read it, you should reset it
  10. Capacitors about which you spoke, they are not necessary, once again check the soldering of the processor, it is difficult to see, but the soldering is not very good
  11. Solder the processor back on the block and throw it on the K-line, I completely forgot to say about it
  12. Have you read any JTAG processors?
  13. Check if the processor is properly installed on the adapter Did you read anything on JTAG?
  14. Adapter H8SX need, read flash, if no flash in the program's database and is not read via CAN to save flash next time you have a unit with that number, and you saved the flash, you can put already at the uart
  15. What is not lucky, does not read?
  16. Maybe the translator does not translate like that, but I said that the renesass H8SX processors are only written by uart, where to get the flash I said above
  17. Use this for gprog, desoldering the CPU https://www.autogenetica.com/stranica-tovara/h8sx-adapter
  18. You should read the CAN, if the block is CAN, or look in the program database These processors are not read by uart, only written
  19. By uart, write only, Renesass processor Read, write on JTAG, the processor is soldered and on the table for gprog
  20. Баги в программе отлавливаются и исправляются, спасибо за понимание и критику.
  21. Почему не последней версией делали? Возможно в 20й версии трабл был, в последней уже исправили.
  22. Помощи просили, хотя бы написали, как восстановили. Закрыть успеем.
  23. Дамп с рабочего блока подойдёт?
  24. Андрей! Поздравляю с днем рождения! Желаю, чтобы вся жизнь была полна радости, счастья, здоровья, улыбок, любви и приятных сюрпризов. Пусть удача станет неотъемлемым спутником, а во всех начинаниях всегда сопутствует только успех. Больше силы, чувств и смелости, чтобы сбывались даже самые необычные желания!
  25. Не помню где взял этот дамп, стал телефон чистить и нашёл, почему подписан так не знаю, но вроде и номер блока и проц такой же, может чем поможет Haval F7_2019_SRS_3658101XQ00A_XC2336A 72F_eeprom_CRASH.bin