Posted April 23, 2020 · Report post hi i am trying to repair this ecu file of a flagship opel or make it virgin if it is possible when i crash by GCTOOL the car clears error but the dump is not ok the car stays blinking the airbag led in the box then I disconnect a sensor of airbag and do not create a fault someone can help me repair the dump or make a virgin thanks. eeprom 1357 8322 ori airbag clear gct.bin eeprom 1357 8322 ori airbag.bin flash 1357 8322 ori airbag.bin 0 Share this post Link to post Share on other sites
Posted April 24, 2020 · Report post В личных сообщениях. Пробуй...... 1 Share this post Link to post Share on other sites
Posted April 26, 2020 · Report post ok I will try these days and inform thanks. 0 Share this post Link to post Share on other sites
Posted April 29, 2020 · Report post hello the file does the same clears the faults but the airbag indicator light stays blinking can there be another solution? thanks. 0 Share this post Link to post Share on other sites
Posted April 29, 2020 · Report post Ошибки какие? 0 Share this post Link to post Share on other sites
Posted April 29, 2020 · Report post У меня нет ошибок, ошибка, которая у меня есть, заключается в том, что индикатор подушки безопасности продолжает мигать, а автомобиль без ошибок. Ошибка состояла в том, что клиент установил диагностический компьютер и неправильно настроил программное обеспечение модуля подушки безопасности, после чего он выдал много ошибок из-за неисправной аппаратной ошибки. В подушке безопасности и связи с этим дампом все эти ошибки устранены, но на панели приборов мигает индикатор подушки безопасности, что-то не так. 0 Share this post Link to post Share on other sites
Posted August 4, 2020 · Report post Its interesting topic, have u solved this? 0 Share this post Link to post Share on other sites
Posted August 4, 2020 · Report post if for I had to buy a unit in the scrapyard because there was no way. 0 Share this post Link to post Share on other sites