llaverosv

note:
a) Do not turn the unit over when the power is connected.
b ) After programming the unit "on the table", it is not recommended to diagnose the unit without connected peripherals (get b1620)
- put the unit in the car.
c) The work with the OBD unit on the car is less qualitative than "on the table", because other blocks that occupy the can when the ignition of the car is switched on interfere with the flash recording.(turn off climate, multimedia, etc.)
d) sometimes, after recording flash on the car, it is not enough to turn off the ignition (the unit is hanging in boot-mode and does not respond to diagnostics) - you need to reset the terminal. (santa fe 2020 test)
e) if you have not completed items "a", "b" and "c" and now you cannot get rid of "b1620", then the situation can be corrected by the initial (first read) dump, cleared in the calculator and recorded by JTAG / UART (recording by CAN will not help anymore) or "reset" (reset) by the module "0119 ProByte"
more info

JOB DONE!! thanks for your comments.  Got a file  from other module with same part number , wrote in my module and NO dtc's and indicator is OFF 

work done !!!. read by CAN lines, and write via UART. 
 
THANKS FOR YOUR SUPPORT

done, thanks the info was in 95M01

Your Clear File is Here
Clear_original 95128 8635a423.BIN