toyota corolla tricore 8917-02t10

[darek 0]

Hello
I have a problem with reading the sensor and it shows the error as in the picture

[kilya31 819]

with external power, you need to read these prots. apply 12 volts to the block connector, the block should lie on the table as it is in the car, disconnect the VCC of the programmer from the block

[darek 0]

external power supply connected, the block is like in the car

[kilya31 819]

Then check the connection from the programmer to the unit, the soldering is bad, make the connection directly from the programmer

[darek 0]

soldering ok, checked connection between the programmer and the srs controller, 12v connected. red not connected

[darek 0]

the computer is diagnosed with a tester

[darek 0]

[kilya31 819]

The last photo is not appropriate, the conversation goes for the processor, and you apply it

Make a connection directly from the programmer with your wires, either the adapter is buggy, or the wire (loop) 

 

[darek 0]

it doesn't even read 93c86

[darek 0]

[kilya31 819]

11 часов назад, darek сказал:

it doesn't even read 93c86

 if there is no contact between the pins of the microcircuit and the pinapim of the programmer. then it won't read

[darek 0]

I take the stand with the memory to the second programmer and read it

[darek 0]

the device is broken, where to send it for repair

[kilya31 819]

Delivery will be more expensive than the repair itself or buy another one, these programmers are no longer produced

[darek 0]

what's the price

[darek 0]

will there be a new yaris, Baracuda fixes